HERE IS A VIDEO DEMONSTRATING HOW I GO FROM CONCEPT TO FINISHED 3D PRINTED PIECE.
This process involved the use of the following software: 3d modeling in Z-brush, C4D, slicing in Cura, Meshmixer, NetFabb basic. The printing was done on an Ultimaker2 using colorfabb PLA. The print time was approximately 42 hours for the body and 4.25 hours for the antlers. The layer height is .6 with a 50 mm/s print speed. Finishing techniques and processes included the use of filer, primer, copper paint and oil paints to create a bronze finish.